Replace the floor sensor

[Tony Spain]

Hej Rickard,
I have replaced my broken T2Floor with a NRG thermostat and it works well. I pulled out the old floor sensor but have been unable to feed in the new sensor because of a tight bend in the conduit. Do you have any smart ideas on how to push in the new floor sensor?
It's working on room temperature at the moment but unfortunately the thermostat is outside the bathroom.
Thanks and sorry about using English.
Cheers
Tony

[Rickard Sellman]

Hi Tony!
Try first to "help" the floorsensor with a pianowire or something when you feed it in. You can also use dishsoup on the sensor to make it run easier in the tube.
If this doesn´t work you must get the floorsensor in to the bathroom and try to set the sensor close to the floor.

Hope you understand? its the first time in English..

Regards Rickard Sellman